User manual

JENSIN® 

DIRECTIONS FOR USE:

CHOOSE AUTOMATIC VOLTAGE STABILIZER:

Voltage stabilizer should select buy True type working voltage stabilizer range suitable and sufficient capacity to.

Voltage stabilizer: Normally just pick a machine with voltage range from 90V to 240V work is enough. Where power is too weak, they must choose from a wide range 60V, 40V to 240V.

Capacity: Attention must be sufficient under the nominal capacity of the equipment used through the voltage stabilizer regulator, to increase reliability & efficiency of the voltage stabilizer regulator; should not use more than 80% of the capacity of the voltage stabilizer regulator.

INSTALLATION:

Preparation: Select the best conductors and large enough. Example: Hard VC 3.0 uses a single wire (diameter 2.0 mm) machine 2KVA; Hard wired single VC 5.0 (diameter 2.5 mm) machine 3KVA. If the wire is too small compared to the required pressure drop on the line, the greater will reduce the capacity of the machine (where the wires have to go too far> 30m rope to use more than 2 times higher than calculated to avoid voltage drop) .

Installation: Place the plant in a cool place, and dry, easy to observe.

· Power on: Connect the grid to pile INPUT (rear). 110V to 110V power grids pile; 220V to 220V power grids pile.

· Power output: OUTPUT Retrieved from piles or from the outlet to power small devices.

· Grounding: ground wire is needed, connect the chassis to the ground (at any public bolts in the chassis).

Close the electricity, the POWER switch to the ON position. Stable idling for about 5 seconds, then turn on the power-electronic equipment used.

USE NOTICE:

· Do not overload.

· When you lose electricity unusual equipment used to cut off the voltage regulator, when the power will turn on again.

· Do not place objects on the machine, especially items containing fluid, easy pouring, flammable, ...

· Do not allow moisture or rain turned into a machine.

· Do not move the machine when there is power.

· For Relay type voltage regulator 300VA and 600VA power does not use a computer or device with large inrush currents (motors, refrigerators, ...

Would like to thank YOU HAVE GOODWILL &SUPPORTED PRODUCTS JENSIN®